Maax Spas - Low Profile Pillow or Non-Skid Step Pad, P10 FitTrac - 111967

Maax Spas - Low Profile Pillow or Non-Skid Step Pad, P10 FitTrac - 111967




***This part will be shipped via FedEx/UPS only****

This item requires 3-5 business days to process and ship





MADE TO FIT SMALL STEPS OR UPPER LIP OF SPAS WHERE IT WORKS AS A CUSHION OR PILLOW

These can be placed in many spots on the tub. 

1.  Place an order for PN 111967.

2.  Locate a relatively smooth area where a pillow or son-skid pad would be helpful.

3.  Clean that area thoroughly with rubbing alcohol and allow it to dry.

4.  Using a razor knife or scoring tool, cut through the paper cover about 3/8” (1cm) from just one edge of the P10 FitTrac pad; then remove this edge of the paper cover.

5.  Carefully position the pad onto its desired location.  Check it from several angles to make sure it looks straight or even.  Peel up and reapply as needed.

6.  Lift the opposite side of the pad (like a hinge) and pull the backing off as the P10 piece is applied to the surface

7.  Apply pressure to secure the P10 pad firmly into place.

8.  Allow the adhesive to set for 72 hours before filling the spa with water.

For best results on curved surfaces, heat with hair dryer or heat gun before applying.

Details:

 - PN 111967

 - Prevents slips on flat surfaces

 - Works as retrofit pillow

 - Resists chlorine, bromine, ozone, etc.

 - Strong adhesive backing

 - Approx. 9.5”W x 4.5” H x 0.25” thick (24cm x 11cm x 0.6cm)